![]() You may use a kitchen towel or tissue paper to clean it, I used my bare hand and do it fast so that it is not too warm to burn my fingers. Lastly, clean the head of the tip to get rid of the residue just before the drawing to keep the work neat. If you have made any mistake during the drawing, just cut it off and redraw a new line to connect if possible.ħ. The filaments are trimmable by using a wire cutter, if you have lots of messy plastic frays on your 3D drawing, just trim them off with a wire cutter, or melt it with the warmed pen tip.Ħ. ![]() ![]() I also find that the warm soft filament hardens quite fast, so if you need to adjust the object, do it immediately before it sets.ĥ. ![]() Try to draw all the lines that are in the same color before switching filament color, changing color too frequently will cause more wastage.Ĥ. On account of the short filaments refill, you will need to keep on refilling it in order to cover a larger area, I find this refilling quite troublesome, hopefully, LIX will have a long continuous length of filaments in the future.ģ. Sun, et al., 3D printing of interdigitated li-ion microbattery. Once you press the extrusion button of the 3D pen, the melted ABS plastic filament flew out quite fast (even though I am using the slower mode) from the tiny tip, it is so soft and wiggling so you will need some practice to get better control and speed coordination between the flow and the movement of your hand.Ģ. Morita, et al., Free-space-wiring fabrication in nano-space by. Here are my experiences and thoughts after using the 3D pen:ġ.
0 Comments
Leave a Reply. |